Barry Mazza 1946 Ford Custom Project
- This topic has 310 replies, 27 voices, and was last updated 4 years, 6 months ago by
.
-
Posts
-
Not sure if it’s the angle of the shot or what but I am not really feeling that rear bumper either seems too curved and too short for the car? May just be the picture but have to say the bumper choices are not my favorite.
I have to agree with you on that Ian.
The bumper choice sure if different from everything I have seen, but they do not flow with the car as well as some other custom bumpers I have seen used on the 41-48 Ford and Mercs.Enjoy the beauty of Customizing
From Barry Mazza….
All cut up and no where to go….start year window frames…another tricky do…
Enjoy the beauty of Customizing
From Barry…
Heat shrink a nasty bulge on hood blocked by hinge plate…can’t figure how that happened.
First smash in..last out..very nasty deep crease in a really bad spot…allmost there.
Enjoy the beauty of Customizing
From Barry…
“After trimming the hood…like a 41..re setting hood latch receiver. ..LOL”
Enjoy the beauty of Customizing
Just heard that Barry is on the Hospital… heart problems.
Get well soon Barry!
Hoping for a speedy recovery.
Enjoy the beauty of Customizing
That’s not good. Here’s hoping he has a speedy and complete recovery! We’re thinking of you Barry!
Dave
Jus' creepin' along..
Barry is back at it….
From Barry Mazza
“Well…after a feeeew back steps….FINALLY. ..a hood that would appear to work…now hood release…”
Enjoy the beauty of Customizing
From Barry…
“Upon completion of my gas shock hood hinge set up, had to redo on side to clear master, get it back and lower hinge bolt comes loose. Factory spot weld gave it up. Off with hood again and repairs made, dam… Hope thats it for hood work.
Enjoy the beauty of Customizing
- You must be logged in to reply to this topic.